How to connect Cursor to X (Twitter)

Evenpost / Answers / How to connect Cursor to X (Twitter)

Cursor cannot post to X by itself this way. Evenpost gives it drafting tools only, so you stay the one who decides what goes out.

First, tell Cursor this and follow the link it prints. You open the link it prints in the browser where you are signed in and tap Allow; the agent never opens it. The page shows a code and your handle. Tap Allow or Deny. The link and its code last 15 minutes. Done. Go back to your terminal. It finishes the setup on its own. The steps below are the older key path.

Connect me to Evenpost: run npx -y -p https://beta.evenpost.app/cli/evenpost-cli-0.1.35.tgz evenpost connect --client cursor and follow the link it prints.

Connect Cursor to X in four steps

1. 01
   Get your keySign in at beta.evenpost.app and choose Create key. It is shown once.
2. 02
   Log in once in a terminalRun the login command from Connect your agent. It asks for the key and hides it.
3. 03
   Add the config entryPaste the evenpost entry from the install page into .cursor/mcp.json in your project, or into ~/.cursor/mcp.json for every project.
4. 04
   Try itAsk Cursor: "Use evenpost account_status". Then pick the "Evenpost this" prompt, or ask: "Draft a 2-tweet thread about this branch and send it to Evenpost".

What happens next

The draft appears in the Evenpost app. Nothing has posted. You read it, edit if you like, and tap Queue, and it goes out with natural spacing in your hours.

In Evenpost

Free during the invite-only beta. What Evenpost is.

Updated 7 Nov 2026